All the details matter! Down to the nuts and bolts, such as these Chimera Engineering Titanium Axle Shaft and Nut that is super light weight, high precision (high tolerance), and super strong.
Chimera Engineering Titanium "Color Series" received a costly coated and finishing process that brings color and shine to titanium like no other. Beside the beautiful finishes, this coating also offers additional hardness, friction and wear reduction. Chimera wanted to offer a completely unique and premium products for the Mini Moto's, elevating the details in the Mini Moto world to the next level!
Axle shaft is raw titanium finish. Installer could customize the thread end finishes via burning it to change the color.
Axle nuts are available in Black, Burnt Blue, Gold, and Raw Titanium.
COMPONENT:
- 1x Axle Shaft (Raw Titanium)
- 2x Axle Nut (available in Black, Burnt Blue, Gold, and Raw Titanium)
- 2x Retainer Pins/Clips
FEATURES:
- CNC-Machined from 6AL-4V Grade 5 Titanium
- M12 x 1.25mm x 270mm Length
- Lightweight
- High Precision (high tolerance)
FITMENT:
- Universal Fitment for anything that accepts 12mm Diameter and 270mm Length
- 2021-2025: Honda Trail 125 (CT125) (REAR)
Will fit the front of the following motorcycles listed below that's using add-on accessories, such as axle sliders, axle spools, axle cups, etc. which may need the additional length. Please measure the thickness of the accessories to make sure the additional 5mm is sufficient. If you're not planning to run any accessories, please look at CH-1512 M12 x 265mm axles for the motorcycles list below.
- 2014-2015: Honda Grom 125 (FRONT W/ Spools/Cups/Sliders)
- 2017-2020: Honda Grom 125 (FRONT W/ Spools/Cups/Sliders)
- 2022-2024: Honda Grom 125 (FRONT W/ Spools/Cups/Sliders)
- 2025 + : Honda Grom 125 (FRONT W/ Spools/Cups/Sliders)
- 2018-2021: Honda Monkey 125 (FRONT W/ Spools/Cups/Sliders)
- 2022-2025: Honda Monkey 125 (FRONT W/ Spools/Cups/Sliders)
- 2024 +: Honda Dax 125 (ST125) (FRONT W/ Spools/Cups/Sliders)
NOTE: When used with stainless steel or titanium axles or bolts, it's recommended to use a little bit of anti seize or MoS2 grease on the threads to prevent galling. Galling is a form of wear caused by adhesion between sliding surfaces. When a material galls, some of it is pulled with the contacting surface, especially if there is a large amount of force compressing the surfaces together.
