Chimera Stainless Steel Front Axle for Honda Monkey GROM 125

Chimera Stainless Steel Front Race Axle! Double nut on each end, making it easier to remove or change any pegs or accessories that you have attached to the axle.

Fits

• Honda Monkey 125 (ALL YEARS)
• Honda GROM 125 (ALL YEARS)

Chimera Stainless Steel Race Front Axle is nutted on both ends, making it easy to remove and to change/replace any accessories such as axle slider and axle peg without the need to remove the axle completely!

Has pre-drilled holes, ready for safety wires and/or hitch-pins/hairpin-clips (NOT INCLUDED).

Fits

• Honda Monkey 125 (ALL YEARS)
• Honda GROM 125 (ALL YEARS)
• +Other application that requires this axle spec.

Axle Specs:

• Diameter: 12mm (0.47" ~ 1/2")
• Overall Length: 272mm (10-7/8").
• Minimum inside length with nuts threaded on = 248mm (9-3/4") from the outer nuts
• Non-threaded center area length = 228mm (8-7/8")
• Machined from stainless steel
• Axle Nuts (2pc) included
• Has pre-drilled holes for safety wires or hitch pins (hairpin clip)
• Will work with nearly every common rear-sets on the market (OEM Stock, Driven Racing, Woodcraft, Spyker, etc).

OEM Grom/Monkey front axle length: 250mm (~9.84")

NOTE: The use of anti-seize on the thread and nut is required on any stainless steel to stainless steel nut and thread application to reduce the chances of the nut seizing to the axle.